Perun ETU V3 Hybrid (universal wiring)

Perun V3 Hybrid replaces mechanical contacts in your airsoft replica or gel blaster and provides lots of useful features. Optical and magnetic sensors allow to eliminate many moving parts that are prone to damage, thus increasing the reliability. Flexible trigger control allows you to adjust the trigger sensitivity from very short to long, even during gameplay, with any trigger and without additional modifications.

Fits most standard Tokyo Marui V3 gearboxes without the need for any modifications. Exceptions are listed in the manual.

Adapted to extreme configurations

Adjustable trigger sensitivity – the trigger can be set to one of 5 sensitivity levels, from a very short pull to a full rearward pull of the trigger. No modifications to the trigger or gearbox are required, and sensitivity can be adjusted even during game.

Fully programmable fire modes – at each selector position (except “safe”), you can set semi-automatic, burst, or full-automatic fire independently of the other positions.

Active brake – active brake stops the motor after each shot preventing spring compression or in case of replicas with high rate of fire, overspin (double shot problem).

Precocking – Fast trigger response can be a matter of victory or defeat, especially in CQB situations. With precocking enabled, piston will remain in rear position after each shot with the spring already compressed, ensuring that next shot will be fired immediately after you pull the trigger. To release the spring after using precocking, pull the trigger and hold it for 2 seconds, after which a second shot will be fired, this time with no precocking and fully braked. To release the spring after using precocking, pull and hold the trigger for 2 seconds. Second shot will be fired, this time with no precocking and fully braked.

Binary trigger – Allows for easy double shots in semi-automatic setting. After enabling this mode, if semi-automatic fire is set, shots will be fired not only when the trigger is pulled, but also when it is released. Following modes are available: semi – burst, semi – auto and burst – auto.

Binary trigger – Allows for easy double shots in semi-automatic setting. When this mode is enabled, single shots will be fired not only when the trigger is pulled but also when it is released.

Rate of fire reduction – reduce the rate of fire in automatic or burst mode to save ammunition or increase realism.

DMR mode – Introduces intervals between semiautomatic shots to comply with DMR rules on some fields.

DSG mode – a sector gear detection mode specially prepared to work with dual sector gears.

Security

Discharged battery alarm – Designed for Li-Po and Li-Ion batteries. If the battery voltage drops to a dangerously low level, the user will be notified by short audible signals repeated every minute.

Diagnostic system – Constantly checks the condition of the electronics and the replica. In the event of a problem, it will immediately provide information about the possible cause, making troubleshooting easier.

Electronic fuse – protects the replica and the battery in the event of a serious malfunction. It will automatically disconnect the battery if a short circuit is detected or if a jam occurs in the gearbox.

Easy to change settings

All settings are changed exclusively using quick and easy‑to‑remember sequences of fire selector movements and trigger pulls.

Programming is supported by sound signals and multicolor LED diode. That allows changing the settings in any moment, in a matter of seconds, even under enemy fire.
All settings are independent for each of the two selector positions, allowing you to configure the replica exactly to your preferences.

Perun V3 Hybrid works flawlessly with any battery rated between 7V and 17V. It can also be used with most extreme setups, without any limitations as to the spring rating.